Welding & Metal Treatment Products // Spatter Protection
- Protection for interior and exterior of MIG nozzles & Electrode welding
- Uniform spray with no air bubbles
- Non-flammable, making it workshop safe
- Provides base metal protection and can be used in all areas
- Contains no silicones which enables no painting or powder coating problems
Callington S-Weld Spatter Guard is a paintable, cost-effective, and non-flammable agent for the prevention of weld-spatter adhering to metal surfaces during the welding process and avoids the need for mechanical abrasion or grinding of weld spatter following welding. It contains corrosion inhibitors for base metal protection.
S-Weld Spatter Guard increases the life cycle of torch components saving time and money. It eliminates spatter build-up which results in poor gas flow causing pitting and porosity. It is suitable for a wide range of steels, including mild steel, stainless, steels, aluminium, and high-performance alloys.
Direction for use
Spray onto the area to be treated, in a thin and uniform film, holding the nozzle approximately 30cm from the surface. NOTE: Wipe the surface with a clean cloth to remove S-Weld Spatter Guard anti-spatter spray prior to painting.
For WELDING TORCH:
Spray S-Weld Spatter-Guard before welding in a thin and uniform film onto the areas to be protected. Hold spray can approximately 30cm from the surface to be protected. Also use the spray to protect the interior and exterior of nozzles, the end and outer surface of contact tips, and all other potential areas which are subject to weld spatter. It may be advisable to spray diffusers and the base of the nozzle support as well.
For BASE METAL:
Spray S-Weld Spatter-Guard hold spray can approximately 30cm from surface to be protected. Spray a thin uniform coating.
|1450/454||454g aerosol can||12 units|