Non Destructive Testing // Cleaners & Removers
- Removes excess penetrant with ease without removing dye from discontinuities.
- Evaporates completely and rapidly, making it ideal for use as a pre and post cleaner for the penetrant inspection process.
- Meets stringent low sulfur and chloride requirements and leaves no residue.
- Greater convenience and portability in aerosol form.
Description
CalCheck™ R-2S is a non-halogenated Cleaner/Remover designed to remove excess penetrant from the test surface during the penetrant process and is used to clean the test area before and after inspection. CalCheck™ R-2S can also be used for cleaning of oily, dirty surfaces, and complies with low sulfur and low halogen requirements. CalCheck™ R-2S is the second step in a simple three step process along with CalCheck™ VP-2S Solvent Removable Penetrant and CalCheck™ D-2S Developer.
Specifications Compliance
• ASME BPVC Section V
• ASTM E165
• AMS2644
Physical Properties
Colour: | Colourless |
Odour: | Low / Characteristic of petroleum distillate |
Density: | 0.72 g/ml |
Viscosity @38oC: | 0.70 cSt |
Flash Point: | 6ºC |
Directions
Note: These instructions describe the basic process, but they may need to be amended by the user to comply with applicable specifications and/or inspection criteria provided by the contracting agency. CalCheck™ R-2S Cleaner/Remover is used for both precleaning and penetrant removal in the process below:
1. SHAKE the aerosol can thoroughly to ensure the contents are consistently mixed.
2. CLEAR the nozzle of the aerosol can before use by depressing the nozzle and position the can around 20cm from the surface of the test area. Note that the ambient temperature and wind (if using outdoors) will require this distance to be changed for optimum performance.
3. PREPARE the test area by cleaning the surface with Cleaner/Remover such as CalCheck™ R-2S. Allow 30 seconds dwell time before wiping CalCheck™ R-2S Cleaner/Remover from the surface with a clean, dry, lint-free rag or towel.
4. APPLY a thin even film of CalCheck™ VP-2S penetrant to the test area. Allow 5-30 minutes dwell time based on any defined procedure requirement.
5. REMOVE excess penetrant from the test area using a lint-free cloth moistened with CalCheck™ R-2S Cleaner/Remover and allow to dry.
6. DEVELOP by spraying CalCheck™ D-2 developer directly on to the test area. Allow 10-30 minutes development time based on any defined procedure requirement.
7. INSPECT the test area for discontinuities under suitable visible lighting.
8. REMOVE all penetrant from the test area by cleaning with CalCheck™ R-2S cleaner/remover.
Ordering Info
Code | Packaging |
---|---|
1563/400 | 400ml (Aerosol) |